Not recommended for use below grade or in joints where abrasion such as foot or wheel traffic is possible.

APPLICATION:

Interface and surfaces must be clean, dry and free of dust, dirt, oil, frost, moisture and water-proofing and release agents. Metal, glass and plastic surfaces should be cleaned with an oil-free solvent and wiped dry. Soap and water are not acceptable. Cut cartridge nozzle for the desired bead size and puncture inner seal. Always apply uniform bead, and tool immediately after application and in one continuous motion to ensure full contact with both sides of the joint area. If used, masking tape should be removed immediately after tooling. Joint depths should not exceed ½” and be no thinner than ⅛”. A thinner bead of product will allow more joint movement than a thick bead.